Schlage Connect Door Lock Wont Connect To Wink Hub

I tried several more times and no luck.

Schlage connect door lock wont connect to wink hub.

This allows you to communicate with your lock via the wink app when you are remote. When you have successfully connected your devices you will see a flashing green check mark on the lock. None of the 3 locks will connect. Then run the pairing command on your lock.

I talked to wink and went through troubleshooting to no luck. In the top right hand corner there s 3 dots click that and choose z wave exclusion. The wink app will also indicate that it has found the lock. To sync your schlage connect smart deadbolt with z wave plus to your wink hub open the wink app on your mobile device and follow the app s instructions.

I ran a exclusion and it did pick up the lock and removed the unknown device. Start by opening up the door keeping it unlocked and press on the schlage button at the top of the keypad. When used with your z wave compatible smart home automation hub alexa connects to your schlage connect smart deadbolt so you can lock your door and check whether or not you locked up before you went to bed by just asking. The lock should now be ready to go for manual usage.

Schlage lock won t connect to hubitat or wink. The lock will blink an orange light for a few seconds then you will get a green check mark on the lock as well as a green flash of light on your wink hub wink hub 2. List of products included in this video. If successful the deadbolt will extend and retract.

Use amazon alexa to control your lock with your voice. I went and replaced the lock thinking something went wrong with it but after installing a new lock it still wont connect. I have reset the locks the hub is within a foot when i try to pair i have a zwave device 3 feet away that is paired new batteries in the locks uninstalled and reinstalled the new st app tried with new and old st app excluded get notification on app it worked and lock shows green check included lock. Make sure the wink hub wink hub 2 is blinking a blue light then press the 0 button on your lock.

They suggested contacting schlage which is a joke. Congratulations you are connected to your schlage touchscreen deadbolt. Get instant notifications whenever the door is unlocked. They have yet to suggest anything to try.

I cannot set up the house lock and hub. From there enter in one of the user codes. And you may be able to completely unpair your lock which allows the lock to be paired again with your hub. My app only shows one lock.

In the new app click your hub from your dashboard. Connect it to your smarthome hub. Bmott0817 april 24 2020 8 17pm 1. Because the schlage connect is powered by z wave you need to pair it with a smart home hub like wink to extend communication with your home s wi fi.